Spark Plugs

Removal

NOTICE: The spark plug wires must be connected correctly, note there location for proper installation. Failure to follow this instruction may result in poor engine performance.

NOTE: Removal steps in this procedure may contain installation details.

1. NOTICE: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.

   NOTE: When removing the spark plug wires from the spark plugs, a slight twisting motion will break the seal and ease removal.

   NOTE: Use compressed air to remove any foreign material from the spark plug wires and surrounding area before removing the spark plug wires.

1. NOTICE: Do not remove the spark plugs when the engine is hot or cold soaked. Spark plug thread or cylinder head damage can occur. Make sure the engine is warm (hand touch after cooling down) prior to spark plug removal.

   NOTICE: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.

   NOTICE: The spark plug procedure must be followed exactly or damage to the cylinder head and spark plug will result.

   NOTICE: The spark plug must be positively located in any assembly aid or tool to prevent the spark plug from falling into the spark plug location, or damage can occur to the cylinder head or to the spark plug.

   NOTICE: If a spark plug is dropped, internal damage may result and the spark plug must be discarded. The use of a damaged spark plug may cause engine damage to occur.

   NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.

   Torque : 15 Nm

Installation

1. Material : Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

1. To install, reverse the removal procedure.
   

Copyright © Ford Motor Company