310-01A Fuel Tank and Lines - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma 2014 Fiesta
Removal and Installation Procedure revision date: 05/7/2013

Fuel Tank

Removal

NOTE: Removal steps in this procedure may contain installation steps.

  1. With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
  1. Release the fuel system pressure.
    Refer to: Fuel System Pressure Release (310-00A Fuel System - General Information - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma, General Procedures).
  1. Drain the fuel tank.
    Refer to: Fuel Tank Draining (310-00A Fuel System - General Information - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma, General Procedures).
  1. Remove the rear seat cusion.
    Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
  1. General Equipment : Hose Clamp(s)
  1. General Equipment : Powertrain Jack
    Torque : 25 Nm

Installation

  1. To install, reverse the removal procedure.