Interior Rear View Mirror

Removal

Mirror type 1

1. NOTICE: Make sure the Mirror Remover is fully inserted into the rear view mirror mount access hole. Otherwise, damage to the windshield glass may occur.

1. Using a closed hand, bump the adjustment handle of the Mirror Remover to slide the mirror upward on the mirror mount.
   

Mirror type 2

1. Special Tool(s) : 501-D118A Mirror Remover

Mirror type 3

Mirror type 4

1. If a new mirror is being installed, upload the IPMA configuration to the scan tool.
   

Mirror type 5

Installation

Mirror type 1

1. Slide the interior rear view mirror over the windshield bracket from the top.
   

1. NOTE: An audible click will be heard as the mirror fully seats.

1. If equipped.
   

1. If equipped with a compass module which requires calibration, check the compass zone and calibration.
   

Mirror type 2

1. Special Tool(s) : 501-025 Installer, Rear View Mirror

1. If equipped with a compass module which requires calibration, check the compass zone and calibration.
   

Mirror type 3

1. To install, reverse the removal procedure.
   

Mirror type 4

1. To install, reverse the removal procedure.
   

1. • If a new mirror has been installed, download the IPMA configuration from the scan tool to the new IPMA .
     
   • If a new mirror has been installed, carry out the camera alignment using a scan tool.
     

Mirror type 5

Copyright © Ford Motor Company