303-00 Engine System - General Information	2014 Fiesta
General Procedures	Procedure revision date: 07/24/2012

Cylinder Block Distortion

NOTE: Refer to the appropriate Section 303-01 for the specification.

NOTE: Use a Straightedge that is calibrated by the manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of length, such as Snap-On® GA438A or equivalent. For example, if the Straightedge is 61 cm (24 in) long, the machined edge must be flat within 0.010 mm (0.0004 in) from end to end.
Use a Straightedge and a Feeler Gauge Set to inspect the cylinder block for flatness.
General Equipment : Feeler Gauge