Oil Pan

Removal

1. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
   

1. General Equipment : Oil Drain Equipment
   Torque : 28 Nm

1. General Equipment : Strap Wrench

1. Pry pads.
   

Installation

1. NOTICE: Do not use metal scrapers, plastic scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leak paths.

   NOTE: Make sure that the mating faces are clean and free of foreign material.

   Do not use any type of scrapers. There is a rubber sealing surface on the bottom of the crankshaft rear seal, take extra care when cleaning the specified area by peeling off the old sealant by hand.
   

1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove traces of sealant.

   NOTE: Make sure that the mating faces are clean and free of foreign material.

   Clean only the specified area with the specified material and a plastic scraping tool to remove traces of sealant.
   Material : Motorcraft® Metal Surface Prep / ZC-31-A
   Material : Motorcraft® Silicone Gasket Remover / ZC-30

1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leak paths. Use a plastic scraping tool to remove traces of sealant.

   NOTE: Make sure that the mating faces are clean and free of foreign material.

   Material : Motorcraft® Metal Surface Prep / ZC-31-A
   Material : Motorcraft® Silicone Gasket Remover / ZC-30

1. Install the following items:

   • NOTE: The use of the two studs will aid in the alignment of the oil pan.

     Two M8x20 studs.
     

1. NOTE: The component must be installed within 5 minutes of applying the sealant.

   Material : Silicone Gasket and Sealant / TA-30 (WSE-M4G323-A4)

1. Remove the following items:
   • Two M8x20 studs.
     

1. NOTE: Only tighten the bolts finger tight at this stage.

1. Torque :
   1 - 4   47 Nm
   5 - 17   10 Nm
   5 - 17   19 Nm

1. 1. Torque : 18 Nm
   2. Torque : 5 Nm

1. Torque : 5 Nm

1. 1. Torque : 15 Nm
   2. Torque : 5 Nm

1. Material : Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)
   Torque : 14.5 Nm

1. Fill the engine with engine oil.
   Material : Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)

Copyright © Ford Motor Company