501-11 Glass, Frames and Mechanisms 2014 Fiesta
General Procedures Procedure revision date: 04/8/2013

Windshield Reseal

  1. Remove the interior rear view mirror.
    Refer to: Interior Rear View Mirror (501-09 Rear View Mirrors, Removal and Installation).
  1. Remove the cowl panel grille.
    Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).

  1. NOTE: On both sides.

    Remove the A-pillar trim panels.
    Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

  1. NOTE: On both sides.

    Remove the B-pillar trim panels.
    Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
  1. On both sides.
  1. On both sides.

  1. NOTE: Windshield removed for clarity.

    Place two blocks of wood spacing the headliner away from the windshield.
    General Equipment : Wooden Block
  1. Clean the interior and exterior of the windshield glass surface with glass cleaner.
    Material : Motorcraft® Ultra-Clear Spray Glass Cleaner / ZC-23 (ESR-M14P5-A)
  1. Cut the urethane adhesive applicator tip to specification.

  1. NOTE: Use a high-ratio, air, electric or battery-operated caulk gun to apply the urethane adhesive with less effort and a continuous bead.

    NOTE: Make sure all gaps in the urethane adhesive are smoothed into one continuous bead.

  1. Apply urethane adhesive over the existing urethane adhesive.
    Material : Betaseal™ Express Dow Urethane Adhesive
    Material : Sika Tack ASAP Urethane Adhesive

  1. NOTE: Allow the urethane adhesive to cure for a minimum of one hour before testing for air or water leaks.

    After the urethane adhesive has cured, check the windshield seal for air or water leaks. Add urethane adhesive as necessary.
    Material : Sika Tack ASAP Urethane Adhesive
    Material : Betaseal™ Express Dow Urethane Adhesive

  1. NOTICE: Make sure not to crease the headliner when removing the wood blocks.

    NOTE: Windshield removed for clarity.

    Remove the blocks and position the front portion of the headliner.
  1. On both sides.
  1. On both sides.

  1. NOTE: On both sides.

    Install the B-pillar trim panels.
    Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

  1. NOTE: On both sides.

    Install the A-pillar trim panels.
    Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
  1. Install the interior rear view mirror.
    Refer to: Interior Rear View Mirror (501-09 Rear View Mirrors, Removal and Installation).
  1. Install the cowl panel grille.
    Refer to: Cowl Panel Grille (501-02 Front End Body Panels, Removal and Installation).
  1. If necessary, remove excess urethane adhesive from the interior and exterior surface of the windshield glass.
    Material : Motorcraft® Ultra-Clear Spray Glass Cleaner / ZC-23 (ESR-M14P5-A)


Copyright © Ford Motor Company