Halfshaft Seal RH

Removal

1. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
   

1. NOTICE: Do not use a prying device or separator fork between the ball joint and the wheel knuckle. Damage to the ball joint or ball joint seal may result. Only use the pry bar by inserting it into the lower arm body opening.

   NOTICE: Use care when releasing the lower arm and wheel knuckle into the resting position or damage to the ball joint seal may occur.

Installation

1. Special Tool(s) : 308-880 Installer, Driveshaft Seal

1. NOTE: Do not fully install the shaft at this time.

   Using part: 97ZT-7M181-A.
   

1. NOTE: Insert the intermediate shaft until the intermediate shaft bearing is centered in the concave groove of the intermediate shaft bearing bracket.

1. Torque :
     Stage 1:  Tighten lower nut to 5 Nm
     Stage 2:  Tighten upper nut to 24 Nm
     Stage 3:  Tighten lower nut to 24 Nm

1. Torque : 52 Nm

1. Torque : 26 Nm

1. Refer to: Transmission Fluid Level Check (308-03B Manual Transmission - Vehicles With: 6-Speed Manual Transmission - B6, General Procedures).
   

1. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
   

Copyright © Ford Motor Company