Halfshaft Seal LH

Removal

1. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
   

1. NOTICE: Do not use a prying device or separator fork between the ball joint and the wheel knuckle. Damage to the ball joint or ball joint seal may result. Only use the pry bar by inserting it into the lower arm body opening.

   NOTICE: Use care when releasing the lower arm and wheel knuckle into the resting position or damage to the ball joint seal may result.

1. Special Tool(s) : 100-001 (T50T-100-A) Slide Hammer , 205-290 (T89P-3415-B) Remover, Halfshaft (Plate) , 205-241 (T86P-3514-A) Remover, Halfshaft

Installation

1. NOTICE: Make sure that the mating faces are clean and free of corrosion and foreign material.

1. Special Tool(s) : 308-848 Installer, Driveshaft Seal

1. NOTE: Do not fully install the shaft at this time.

   Using part: 97ZT-7M181-A.
   

1. NOTE: Insert shaft until circlip is fully seated. When checking if circlip is seated do not pull on CV joints or damage can result.

1. Torque : 52 Nm

1. Torque : 26 Nm

1. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
   

1. Refer to: Transmission Fluid Level Check (308-03A Manual Transmission - Vehicles With: 5-Speed Manual Transmission - B5/IB5, General Procedures).
   

Copyright © Ford Motor Company