SYNC Module [APIM] to Universal Serial Bus (USB) Port Cable

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: The instrument panel and floor console USB cables are taped into the wiring harness. Because the USB cables cannot be removed from the harness, this procedure applies to replacement of the cables only.

Instrument panel USB cable

1. Refer to: Front Display Interface Module (FDIM) (415-00C Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display, Removal and Installation).
   

Floor console USB cable

1. Refer to: Floor Console (501-12 Instrument Panel and Console, Removal and Installation).
   

Installation

Instrument panel USB cable

1. NOTE: For cable routing, view shown from the cowl behind the in-vehicle cross beam.

   • Overlay the new USB cable following the routing shown.
     
   • Secure the new USB cable to the wiring harness with tape or zip ties as necessary.
     
   • Cut both ends off the original USB cable.
     

Floor console USB cable

1. NOTE: For cable routing, view shown with floor console installed in vehicle.

   • Overlay the new USB cable following the routing shown.
     
   • Secure the new USB cable to the wiring harness with tape or zip ties as necessary.
     
   • Cut both ends off the original USB cable.
     

Copyright © Ford Motor Company