Spark Plug Wires

Removal

NOTICE: The spark plug wires must be connected correctly, note there location for proper installation. Failure to follow this instruction may result in poor engine performance.

NOTE: Removal steps in this procedure may contain installation details.

1. NOTICE: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.

   NOTE: Use compressed air to remove any foreign material from the spark plug wires and surrounding area before removing the spark plug wires.

   NOTE: When removing the spark plug wires from the spark plugs, a slight twisting motion will break the seal and ease removal.

   NOTE: Disconnect the spark plug wires from the ignition coil by slightly twisting while pulling upwards.

Installation

NOTE: Wipe the ignition coil assemblies coil towers with a clean cloth dampened with soap and water. Remove any soap film and dry with compressed air. Inspect for cracks, carbon tracking and dirt. Replace any damaged spark plug wires.

1. Material : Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

1. To install, reverse the removal procedure.
   

Copyright © Ford Motor Company