501-20B Supplemental Restraint System 2014 Fiesta
Removal and Installation Procedure revision date: 04/30/2013

C-Pillar Side Impact Sensor

Removal

NOTE: RH side shown, LH side similar.

NOTE: To avoid damage to the trim panels, remove any retaining clips from the body and attach them to the trim panels before installing.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

  1. Depower the SRS .
    Refer to: Supplemental Restraint System (SRS) Depowering and Repowering (501-20B Supplemental Restraint System, General Procedures).

4-door

  1. NOTE: Rear seat and safety belt removed for clarity.

All vehicles

  1. NOTE: 4-door shown, 5-door similar.

  1. Torque : 10.5 Nm

Installation

  1. NOTE: Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.

    To install, reverse the removal procedure.
  1. Repower the SRS .
    Refer to: Supplemental Restraint System (SRS) Depowering and Repowering (501-20B Supplemental Restraint System, General Procedures).