307-01 Automatic Transmission - Vehicles With: 6-Speed PowerShift Transmission - DPS6/6DCT250 2014 Fiesta
Disassembly and Assembly of Subassemblies Procedure revision date: 04/29/2013

Differential

DISASSEMBLY

  1. NOTICE: Take care not to damage the differential impulse ring.

    Special Tool(s) : 204-069 (T81P-1104-C) Remover/Installer, Front Wheel Hub
    General Equipment : Bearing Separator
  1. Remove and discard the differential ring gear bolts. Lightly tap the ring gear to separate it from the differential case.
  1. Clean all parts in clean solvent and dry with compressed air.

ASSEMBLY

  1. Inspect differential parts for damage or wear. Repair or replace as needed.
  1. Install the differential ring gear onto the differential case.
  1. Install the new differential ring gear bolts. Tighten the differential ring gear bolts in the sequence shown.
    Torque : 85 Nm
  1. NOTE: Make sure the differential impulse ring is fully seated and flush on the differential.

    Slightly heat the differential impulse ring. Install it onto the differential assembly.
    Special Tool(s) : 300-MASHG501AE 500-750 Degree Heat Gun
  1. Special Tool(s) : 205-206 (T83T-4221-A) Installer, Differential Bearing , 205-153 (T80T-4000-W) Handle