303-01A Engine - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma 2014 Fiesta
Removal and Installation Procedure revision date: 05/2/2013

Oil Cooler

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.

    Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
  1. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
  1. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing the oil filter.

    General Equipment : Oil Drain Equipment
    General Equipment : Strap Wrench
    Material : Motorcraft® SAE 5W-20 Premium Synthetic Blend Motor Oil / XO-5W20-QSP (WSS-M2C945-A)
    Torque : 15 Nm
  1. General Equipment : Locking Pliers
  1. NOTICE: If metal or aluminum material is present in the oil cooler, mechanical concerns exist. Failure to correct these concerns may cause engine failure.

    To diagnose mechanical concerns.
    Refer to: Engine (303-00 Engine System - General Information, Diagnosis and Testing).
    General Equipment : Oil Drain Equipment
    Torque : 55 Nm

Installation

  1. To install, reverse the removal procedure.