Ignition Coil-On-Plug

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Quick Release Coupling (310-00B Fuel System - General Information - 1.6L EcoBoost (132kW/180PS) - Sigma, General Procedures).
   

1. NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.

   NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.

   NOTE: When installing the ignition coil-on-plugs, apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.

   1. NOTE: If equipped with a sliding cover over the locking tab, then slide the cover back to gain access to the tab.

      Depress the locking tab on the ignition coil-on-plug electrical connector, and disconnect the electrical connector from the ignition coil-on-plug.
      
   2. Torque : 10 Nm
   3. Material : Silicone Brake Caliper Grease and Dielectric Compound / XG-3-A (ESE-M1C171-A)

1. Replace any coil-on-plug assemblies with cracks, rips, or tears.
   

Installation

1. To install, reverse the removal procedure.
   

Copyright © Ford Motor Company