|309-00B Exhaust System - 1.6L EcoBoost (132kW/180PS) - Sigma||2014 Fiesta|
|Removal and Installation||Procedure revision date: 04/18/2013|
NOTICE: The production muffler and tailpipe assembly is one-piece construction. The service muffler and tailpipe is 2-piece construction. It is necessary to cut the production exhaust system to enable the service section(s) to be fitted. Before cutting any part of the exhaust system, check that the position of the cut is correct in comparison to the service sections to be installed.
NOTE: Service section part(s) use a service section clamp for assembly.
NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components.
NOTICE: Do not forcibly bend or twist the exhaust flexible pipe. Failure to follow these instructions may cause damage to the flexible pipe.
NOTE: The 1.6L Duratec muffler and tailpipe assembly shown, 1.6L Ecoboost similar.General Equipment : Air Body Saw
NOTE: If the rear muffler and tailpipe section is being serviced, the rear muffler service part is sized to overlap the front muffler and tailpipe section (shown). If the front muffler and tailpipe section is being serviced, install the service sleeve and clamp.
NOTE: The 1.6L Duratec muffler and tailpipe assembly shown, 1.6L Ecoboost similar.
Copyright © Ford Motor Company