Rear Seat Backrest Cover

Removal

NOTE: 60 percent seat shown, 40 percent seat similar.

NOTE: Removal steps in this procedure may contain installation details.

1. Refer to: Rear Seat Backrest (501-10 Seating, Removal and Installation).
   

1. General Equipment : Flat Headed Screw Driver

1. Torque : 35 Nm

1. NOTE: 5-door only.

1. NOTE: 5-door shown, 4-door similar.

1. NOTE: 5-door shown, 4-door similar.

Installation

1. To install, reverse the removal procedure.
   General Equipment : Hog Ring Plier

1. NOTICE: Always install new head restraint guide sleeves. Difficult adjustment of the head restraint may occur. Failure to follow these instructions may result in component failure.

   NOTICE: The head restraint guide sleeves are not interchangeable. Failure to install the correct head restraint guide sleeves at the correct position may result in component failure.

   NOTE: To allow the head restraint guide sleeve to slide freely through the backrest foam pad and backrest trim cover, twist the head restraint guide sleeve to align the keyway tabs while pushing it into the backrest frame hole as far as it will go with hand pressure

   On both sides.
   

Copyright © Ford Motor Company