303-14A Electronic Engine Controls - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma | 2014 Fiesta |
Removal and Installation | Procedure revision date: 04/18/2013 |
Removal
NOTE: This step is only necessary when installing a new component.
NOTE: The PMI (programmable module installation) process must begin with the current PCM installed. If the current PCM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.
Using a diagnostic scan tool, begin the PMI process for the PCM following the on-screen instructions.Installation
NOTE: The step is only necessary when installing a new component.
Using a diagnostic scan tool, complete the PMI process for the PCM following the on-screen instructions.NOTE: The step is only necessary when installing a new component.
Copyright © Ford Motor Company