Instrument Panel Cluster (IPC)

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: If installing a new IPC , all vehicle keys are erased during the parameter reset procedure. Verify at least 2 of the vehicle keys are available prior to carrying out this procedure.

NOTE: If a new IPC without push button start is installed, the IPC and the PCM require a parameter reset to allow the IPC and the PCM to recognize each other. Failure to carry out the parameter reset to the IPC and the PCM may result in a no start condition.

1. NOTE: This step is only necessary when installing a new component.

   NOTE: The PMI process must begin with the current IPC installed. If the current IPC does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

   Using a diagnostic scan tool, begin the PMI process for the IPC following the on-screen instructions.
   

1. Torque : 2 Nm

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   NOTE: If installing a new push button start IPC remove relay R7 from the CJB and jumper pins 3 and 5 together. After configration, remove the jumper and reinstall relay R7.

   Using a diagnostic scan tool, complete the PMI process for the IPC following the on-screen instructions.
   

1. If installing a new IPC without push button start, carry out the parameter reset procedure.
   Refer to: Module Configuration - System Operation and Component Description (418-01 Module Configuration, Description and Operation).
   

1. If installing a new IPC without push button start, carry out the key programming procedure.
   Refer to: Key Programming Using Diagnostic Equipment (419-01B Passive Anti-Theft System (PATS) - Vehicles Without: Keyless Entry and Push Button Start, General Procedures).
   

Copyright © Ford Motor Company