206-06 Hydraulic Brake Actuation 2014 Fiesta
Removal and Installation Procedure revision date: 08/12/2013

Brake Master Cylinder

Removal

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

  1. Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
    Refer to: Battery Tray - 1.0L EcoBoost (90kW/120PS)/1.6L EcoBoost (132kW/180PS) - Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
  1. Torque : 7 Nm

Vehicles with manual transmission

All vehicles

  1. Torque : 17 Nm

  1. NOTE: Before installing the master cylinder make sure a new brake booster-to-master cylinder O-ring is in place and the mating faces are clean.

    Torque : 20 Nm

  1. NOTICE: Take extra care when handling the component.

Installation

All vehicles

  1. NOTE: This step is only necessary when installing a new component.

  1. To install, reverse the removal procedure.
  1. Refer to: Component Bleeding (206-00 Brake System - General Information, General Procedures).

Vehicles with manual transmission

  1. Refer to: Clutch System Bleeding (308-02 Clutch Controls - Vehicles With: 5-Speed Manual Transmission - B5/IB5/6-Speed Manual Transmission - B6, General Procedures).


Copyright © Ford Motor Company