Transmission

1. 1. NOTE: Make sure that a new component is installed.

   2. Torque : 22 Nm

1. 1. NOTE: Make sure that a new component is installed.

   2. Special Tool(s) : 308-041 Installer, Input Shaft Bearing Cone

1. 2. NOTE: Make sure that new components are installed.

1. Special Tool(s) : 205-075 Installer, Rear Wheel Hub Seal

1. Material : Gasket Maker / TA-16 (WSK-M2G348-A5)

1. Torque : 22 Nm

1. Torque :
     Stage 1:  12 Nm
     Stage 2:  17 Nm

1. Remove the following items:
   1. Transmission
      

1. 2. Special Tool(s) : 308-045 Installer, Transmission Extension Housing Bushing/Seal
      General Equipment : Hydraulic Press

1. Install the following items:
   1. Transmission
      

1. NOTE: Make sure that a new component is installed.

1. 2. NOTE: Make sure that a new component is installed.

      Torque : 25 Nm

1. NOTE: This step is only necessary if the original component is to be reused.

   NOTE: Make sure that these components are installed to the position noted before removal.

1. NOTE: Make sure that these components are installed to the position noted before removal.

1. NOTE: Make sure that these components are installed to the position noted before removal.

1. NOTE: This step is only necessary if the original component is to be reused.

   NOTE: Make sure that a new component is installed.

   General Equipment : Punch

1. NOTE: This step is only necessary if the original component is to be reused.

   NOTE: Make sure that a new component is installed.

1. Material : Silicone Gasket and Sealant / TA-30 (WSE-M4G323-A4)

1. Torque : 12 Nm

1. 1. Torque : 20 Nm
   2. Torque : 46 Nm

1. NOTE: Make sure that a new component is installed.

1. • NOTICE: Make sure that a new bolt is installed.

     Torque : 25 Nm

1. NOTE: Make sure that a new component is installed.

1. Special Tool(s) : 308-848 Installer, Driveshaft Seal

1. Special Tool(s) : 205-115A Installer, Drive Pinion Seal

1. Torque : 5 Nm

1. 1. NOTICE: Use adhesive tape to cover the input shaft splines to prevent damage to the input shaft seal.

      General Equipment : Adhesive Tape

   2. NOTE: Make sure that a new component is installed.

   3. Special Tool(s) : 205-068 Installer, Drive Pinion Bearing
   4. Remove the adhesive tape from the input shaft splines.
      

1. Torque : 11 Nm

1. Remove Special Service Tool : 307-003 (T57L-500-B) Holding Fixture, Transmission

Copyright © Ford Motor Company