303-01B Engine - 1.6L EcoBoost (132kW/180PS) - Sigma	2014 Fiesta
Removal and Installation	Procedure revision date: 05/15/2013

Crankshaft Rear Seal

Removal

Remove the following items:
1. Refer to: Flywheel (303-01A Engine - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma, Removal and Installation).
2. Refer to: Oil Pan (303-01A Engine - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma, Removal and Installation).

Installation

NOTE: Make sure that the mating faces are clean and free of foreign material.

NOTE: The new crankshaft rear seal is supplied with an alignment sleeve which must be removed after installation.

NOTE: Do not remove the alignment sleeve from the crankshaft rear seal prior to installation on the crankshaft.
1. Align the crankshaft rear seal and alignment sleeve on the crankshaft and push the crankshaft rear seal off the alignment sleeve onto the crankshaft without stopping until the crankshaft rear seal meets the cylinder block.
  Torque :
  Stage 1: Tighten bolts 1 through 6 to 4 Nm
  Stage 2: Tighten bolts 1 through 6 to 10 Nm
1. Remove the alignment sleeve.

Install the following items:
1. Refer to: Oil Pan (303-01A Engine - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma, Removal and Installation).
2. Refer to: Flywheel (303-01A Engine - 1.6L Duratec-16V Ti-VCT (88kW/120PS) - Sigma, Removal and Installation).